Users Guide

Using the CLI
Use the following command to configure RF Optimization profiles. The parameters described in Table 122.
rf optimization-profile <profile>
clone <profile>
handoff-assist
low-rssi-threshold <number>
no ...
rssi-check-frequency <number>
rssi-falloff-wait-time <seconds>
RF Event Configuration
An AP’s event threshold profile configures Received Signal Strength Indication (RSSI) metrics, including high and
low watermarks for frame error rates and frame retry rates. When certain RF parameters are exceeded, these
events can signal excessive load on the network, excessive interference, or faulty equipment.
This profile and many of the detection parameters are disabled (value is 0) by default.
The following procedure details the steps to configure RF Event parameters.
Using the WebUI
1. Navigate to the Configuration > Wireless > AP Configuration window. Select either the AP Group or
AP Specific tab.
l If you selected the AP Group tab, click the Edit button by the AP group name for which you want to
configure the RF Event profile.
l If you selected the AP Specific tab, click the Edit button by the AP for which you want to create the RF
Event profile.
2. In the Profiles list, expand the RF Management menu, then expand the RF Event Profile menu.
3. To edit an existing RF Event profile, select the profile you want to edit from the Profile Details window
pane.
-or-
4. To create a new profile, enter a new RF Event profile name in the field at the bottom of the Profile Details
window, then click Add. Next, select that profile name from the profile list to edit its parameters.
5. Configure your settings as detailed in Table 123 and click Apply to save your settings.
Dell Networking W-Series ArubaOS 6.5.x | User Guide Access Points | 556