Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series Controller AOS
441442443444445446447448449450
Table Of Contents
445| Virtual APs Dell Networking W-Series ArubaOS 6.5.x| User Guide
Parameter Description
Maximum number of MSDUs in an A-MSDU on
background AC
Set the maximum number of MSDUs in a TX A-MSDU on
background AC.
Default: 2.
NOTE: TX A-MSDU is disabled if the value is set to 0. In
decrypt-tunnel forwarding mode, TX A-MSDU on
background AC is disabled and assigning any value has no
effect.
Maximum number of MSDUs in an A-MSDU on
video AC
Set the maximum number of MSDUs in a TX A-MSDU on
video AC.
Default: 2.
NOTE: TX A-MSDU is disabled if the value is set to 0. In
decrypt-tunnel forwarding mode, TX A-MSDU on video AC is
disabled and assigning any value has no effect.
Maximum number of MSDUs in an A-MSDU on
voice AC
Set the maximum number of MSDUs in a TX A-MSDU on
voice AC.
Default: 0.
NOTE: TX A-MSDU is disabled if the value is set to 0. In
decrypt-tunnel forwarding mode, TX A-MSDU on voice AC is
disabled and assigning any value has no effect.
Table 99: High-Throughput SSID Profile Parameters
In order for the settings in this profile to take effect, the profile must be associated with an AP's Virtual AP
profile. For details on associating a high-throughput SSID profile with a Virtual APprofile, see Configuring the
Virtual AP Profile on page 410
In the CLI
(host)(config) #wlan ht-ssid-profile <profile-name>
Guest WLANs
Guest usage in enterprise wireless networks requires the following special consideration:
l Guest users must be separated from employee users by VLANs in the network.
l Guests must be limited not only in where they may go, but also by what network protocols and ports they
may use to access resources.
l Guests should be allowed to access only the local resources that are required for IP connectivity. These
resources include DHCP and possibly DNS if an outside DNS server is not available. In most cases, a public
DNS is always available.
l All other internal resources should be off limits for the guest. This restriction is achieved usually by denying
any internal address space to the guest user.
l A time-of-day restriction policy should be used to allow guests to access the network only during normal
working hours, because they should be using the network only while conducting official business. A rate
limit can also be put on each guest user to keep the user from using up the limited wireless bandwidth.
Accounts should be set to expire when their local work is completed, typically at the end of each business
day.