Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series Controller AOS
431432433434435436437438439440
Table Of Contents
Parameter Description
Deny_Broadcast Probes When a client sends a broadcast probe request frame to search for all
available SSIDs, this option controls whether or not the system responds for
this SSID. When enabled, no response is sent and clients have to know the
SSID in order to associate to the SSID. When disabled, a probe response
frame is sent for this SSID.
Local Probe Request
Threshold (dB)
Enter the SNR threshold below which incoming probe requests will get
ignored. The supported range of values is 0-100 dB. A value of 0 disables this
feature.
Disable Probe Retry Click this checkbox to enable or disable battery MAC level retries for probe
response frames. By default this parameter is enabled, which mean that MAC
level retries for probe response frames is disabled.
NOTE: This parameter is not supported for W-AP200 Series access points.
Battery Boost Converts multicast traffic to unicast before delivery to the client, thus allowing
you to set a longer DTIM interval. The longer interval keeps associated
wireless clients from activating their radios for multicast indication and
delivery, leaving them in power-save mode longer and thus lengthening
battery life.
This parameter requires the PEFNG license.
WEP Key 1 First static WEP key associated with the key index. Can be 10 or 26 hex
characters in length.
WEP Key 2 Second static WEP key associated with the key index. Can be 10 or 26 hex
characters in length.
WEP Key 3 Third Static WEP key associated with the key index. Can be 10 or 26 hex
characters in length.
WEP Key 4 Fourth Static WEP key associated with the key index. Can be 10 or 26 hex
characters in length.
WEP Transmit Key Index Key index that specifies which static WEP key is to be used. Can be 1, 2, 3, or 4.
WPA Hexkey WPA pre-shared key (PSK).
WPA Passphrase WPA passphrase with which to generate a pre-shared key (PSK).
Maximum Transmit
Failures
The AP assumes the client has left and should be deauthorized when the AP
detects this number of consecutive frames were not delivered because the
maximum retry threshold as been exceeded.
Table 96: SSID Profile Parameters
Dell Networking W-Series ArubaOS 6.5.x | User Guide Virtual APs |
434