Users Guide

419| Virtual APs Dell Networking W-Series ArubaOS 6.5.x| User Guide
4. Configure your 802.11k radio settings.
Table 91 outlines the parameters you can configure in the 802.11k
profile. Click Apply to save your settings.
Parameter Description
Advertise
802.11k
Capability
Select this option to allow Virtual APs using this profile to advertise
802.11k capability.
Default: Disabled
Forcefully
disassociate
on-hook
voice clients
Select this option to allow the AP to forcefully disassociate on-hook
voice clients (clients that are not on a call) after period of inactivity.
Without the forced disassociation feature, if an AP has reached its call
admission control limits and an on-hook voice client wants to start a
new call, that client may be denied. If forced disassociation is enabled,
those clients can associate to a neighboring AP that can fulfill their
QoS requirements.
Default: Disabled
Measureme
nt Mode for
Beacon
Reports
Click the Measurement Mode for Beacon Reports drop-down list
and specify one of the following measurement modes:
l active-all-ch—Enables active beacon measurement mode. In this
mode, the client sends a probe request to the broadcast
destination address on all supported channels, sets a
measurement duration timer, and, at the end of the measurement
duration, compiles all received beacons or probe response with
the requested SSID and BSSID into a measurement report.
l active-ch-rpt—In this mode, the client and returns a report that
contains a list of channels in a regulatory class where a client is
likely to find an AP, including the AP transmitting the AP channel
report.
l beacon-table—Enables beacon-table beacon measurement
mode. In this mode, the client measures beacons and returns a
report with stored beacon information for any supported channel
with the requested SSID and BSSID. The client does not perform
any additional measurements.
l passive—Enables passive beacon measurement mode. In this
mode, the client sets a measurement duration timer, and, at the
end of the measurement duration, compiles all received beacons
or probe response with the requested SSID and BSSID into a
measurement report.
NOTE: If a station doesn't support the selected measurement mode,
it returns a Beacon Measurement Report with the Incapable bit set in
the Measurement Report Mode field.
Default Mode: beacon-table
Channel for
Beacon
Requests in
'A' band
This value is sent in the 'Channel' field of the beacon requests on the
'A' radio. You can specify values in the range 34 to 165. The default
value is 36.
Channel for
Beacon
This value is sent in the 'Channel' field of the Beacon Requests on the
'BG' radio. You can specify values in the range 1 to 14. The default
value is 1.
Table 91: 802.11k Profile Parameters