Users Guide

411| Virtual APs Dell Networking W-Series ArubaOS 6.5.x| User Guide
Parameter Description
mode.
l Bridge: 802.11 frames are bridged into the local Ethernet LAN. When a remote
AP or campus AP is in bridge mode, the AP (and not the controller) handles all
802.11 association requests and responses, encryption/decryption processes,
and firewall enforcement. The 802.11e and 802.11k action frames are also
processed by the AP, which then sends out responses as needed.
An AP in bridge mode does not support captive portal authentication. Both
remote and campus APs can be configured in bridge mode. Note that you must
enable the control plane security feature on the controller before you configure
campus APs in bridge mode.
l Split-Tunnel: 802.11 frames are either tunneled or bridged, depending on the
destination (corporate traffic goes to the controller, and Internet access
remains local).
A remote AP in split-tunnel forwarding mode handles all 802.11 association
requests and responses, encryption/decryption, and firewall enforcement. the
802.11e and 802.11k action frames are also processed by the remote AP, which
then sends out responses as needed.
l Decrypt-Tunnel: Both remote and campus APs can be configured in decrypt-
tunnel mode. When an AP uses decrypt-tunnel forwarding mode, that AP
decrypts and decapsulates all 802.11 frames from a client and sends the 802.3
frames through the GRE tunnel to the controller, which then applies firewall
policies to the user traffic.
When the controller sends traffic to a client, the controller sends 802.3 traffic
through the GRE tunnel to the AP, which then converts it to encrypted 802.11
and forwards to the client. This forwarding mode allows a network to utilize the
encryption/decryption capacity of the AP while reducing the demand for
processing resources on the controller.
APs in decrypt-tunnel forwarding mode also manage all 802.11 association
requests and responses, and process all 802.11e and 802.11k action frames.
APs using decrypt-tunnel mode do have some limitations that not present for
APs in regular tunnel forwarding mode.
You must enable the control plane security feature on the controller before you
configure campus APs in decrypt-tunnel forward mode.
NOTE: Virtual APs in bridge or split-tunnel mode using static WEP should use key
slots 2–4 on the controller. Key slot 1 should only be used with Virtual APs in tunnel
mode.
Allowed band The band(s) on which to use the virtual AP:
l a—802.11a band only (5 GHz).
l g—802.11b/g band only (2.4 GHz).
l all—both 802.11a and 802.11b/g bands (5 GHz and 2.4 GHz). This is the
default setting.
Band Steering ARM’s band steering feature encourages dual-band capable clients to stay on the
5GHz band on dual-band APs. This frees up resources on the 2.4GHz band for
single band clients like VoIP phones.
Table 90: Virtual AP Profile Parameters