Users Guide

377| Roles and Policies Dell Networking W-Series ArubaOS 6.5.x| User Guide
l If you selected Range, enter the starting and ending port numbers in the Starting Port and End Port
fields.
l If you selected list, enter a comma-separated list of port numbers.
6. To limit the service alias to a specific application, click the Application Level Gateway (ALG) drop-down
list and select one of the following service types
l dhcp: Service is DHCP
l dns: Service is DNS
l ftp: Service is FTP
l h323: Service is H323
l noe: Service is Alcatel NOE
l rtsp: Service is RTSP
l sccp: Service is SCCP
l sip: Service is SIP
l sips: Service is Secure SIP
l svp: Service is SVP
l tftp: Service is TFTP
l vocera: Service is VOCERA
7. Click Apply to save your changes.
In the CLI
To define a service alias via the command-line interface, issue the following command:
(host)(config) #netservice <name> <protocol>|tcp|udp {list <port>,<port>}|{<port> [<port>]}
[ALG <service>]
Creating an ACL White List
The ACL White List consists of rules that explicitly permit or deny session traffic from being forwarded to or
blocked from the controller. The white list protects the controller during traffic session processing by
prohibiting traffic from being automatically forwarded to the controller if it was not specifically denied in a
blacklist. The maximum number of entries allowed in the ACL White List is 64. To create an ACL white list, you
must first define a white list bandwidth contract, and then assign it to an ACL.
Creating a Bandwidth Contract in the WebUI
1. Navigate to the Configuration > Advanced Services > Stateful Firewall > White List BW Contracts
page.
2. Click Add to create a new contract.
3. In the White list contract name field, enter the name of a bandwidth contract.
4. The Bandwidth Rate field allows you to define a bandwidth rate in either kbps or Mbps. Enter a rate value
the Bandwidth rate field, then click the drop-down list and select either kbps or Mbps.
5. Click Done.
Configuring the ACL White List in the WebUI
1. Navigate to the Configuration > Stateful Firewall> ACL White List page.
2. To add an entry, click the Add button at the bottom of the page. The Add New Protocol section displays.
3. Click the Action drop-down list and select Permit or Deny. Permit allows session traffic to be forwarded
to the controller while Deny blocks session traffic.