Users Guide

Parameter Description
Probe Interval (sec)
The Probe Interval field specifies the probe interval, in seconds. The WAN
health-check feature sends the number of probes defined by the Packet Burst
per Probe parameter during each probe interval. To change the default interval
of 10 seconds, enter a new value into this field.
PacketBurst Per Probe
The Pocket Burst per Probe field specifies the number of probes to be sent
during the probe interval. To change the default value of 5 probes, enter a new
value into this field.
Probe Retries
The number of times the controller will attempt to resend a probe.
IP/FQDN of remote host IPaddress or Fully Qualified Domain Name (FQDN) of the remote host to which
the ping probes are sent.
Jitter Measurement Jitter is a variation in the delay of received packets, which can be worsened by
network congestion, improper queueing and configuration errors. The WAN
health-check feature measures jitter on the connection to the remote host by
sending and measuring packets at fixed intervals.
PBR Select the PBRtab to define ping probe settings for policy-based routing.
Probe Mode
Click the Probe Mode drop-down list and select ping to enable ip probes.
Probe Interval (sec)
The Probe Interval field specifies the probe interval, in seconds. The WAN
health-check feature sends the number of probes defined by the Packet Burst
per Probe parameter during each probe interval. To change the default interval
of 10 seconds, enter a new value into this field.
PacketBurst Per Probe
The Pocket Burst per Probe field specifies the number of probes to be sent
during the probe interval. To change the default value of 5 probes, enter a new
value into this field.
Probe Retries
The number of times the controller will attempt to resend a probe.
WAN Optimization
Compression The Compression/Decompression Engine feature is enabled by default. However,
the packets are compressed only if the IP Payload Compression Protocol (IPComp)
is successfully negotiated via the Internet Key Exchange (IKE) protocol.
BW Management
Uplink
Select an interface uplink to which you will apply the bandwidth contract.
Service Type
Select one of the available service types for this bandwidth contract:
l None: The contract applies to all upstream or downstream traffic on the
interface.
l Application: The contract applies to a specific application.
Table 63: Branch Config Group WAN Setting
Dell Networking W-Series ArubaOS 6.5.x | User Guide BranchController Config for Controllers |
247