Users Guide

159| OSPFv2 Dell Networking W-Series ArubaOS 6.5.x| User Guide
M - mgmt, U - route usable, * - candidate default
The routing table for the central office controller is below:
(host)#show ip route
Gateway of last resort is 4.1.1.2 to network 0.0.0.0
O* 0.0.0.0/0 [1/0] via 4.1.1.2*
O 14.1.1.0/24 [1/0] via 30.1.1.1*
O 15.1.1.0/24 [1/0] via 30.1.1.1*
C 4.1.1.0 is directly connected, VLAN4
C 5.1.1.0 is directly connected, VLAN5
C 20.1.1.0 is directly connected, Tunnel 1
The routing table for Router 1 is below:
(router1) #show ip route
O 14.1.1.0/24 [1/0] via 4.1.1.1
O 15.1.1.0/24 [1/0] via 4.1.1.1
C 4.1.1.0 is directly connected, VLAN4
The routing table for Router 2 is below:
(router2) #show ip route
O 14.1.1.0/24 [1/0] via 5.1.1.1
O 15.1.1.0/24 [1/0] via 5.1.1.1
C 5.1.1.0 is directly connected, VLAN5
Configuring OSPF
To configure general OSPF settings from the OSPF tab, perform the following steps:
1. Navigate to the Configuration >IP page (see Figure 30). The Area and Excluded subnets are displayed in
table format. If not explicitly specified for OSPF, the router ID defaults to the switch IP.
Figure 30 General OSPF Configuration
2. Click Add to add an area (see Figure 31).