Users Guide

Table 236 shows the location attributes a device can register with CPPM and the corresponding behavior on
the controller:
Location Attribute Tag=Value Format Description
AP-Name based ap-name=<name> When the location is set to ap-name, all AirGroup
users connected to this AP and other APs that are in
the same RF neighborhood can access the shared
device.
AP-Group based ap-group=<group> When the location attribute is set to ap-group, all
AirGroup users associated to the APs in the
specified AP group can access the shared device.
AP-FQLN based fqln=<fqln> When the location attribute is set to ap-FQLN, all
AirGroup users connected to APs on the same floor,
and to the APs on a floor above or below the
configured APs can access the shared device.
Table 236: Location Attributes in CPPM
In the CLI
Access the controller’s command-line interface and use the following command to enable or disable the
AirGroup Global Setting:
(host) (config) #airgroup {enable | disable}
(host) (config) #airgroup cppm-server enforce-registration
(host) (config) #airgroup ipv6
(host) (config) #airgroup query-interval <1..24>
(host) (config) #airgroup location-discovery {enable | disable}
(host) (config) #airgroup active-wireless-discovery {enable | disable}
Enabling or Disabling mDNS and DLNA
You can enable and disable mDNS and DLNA using CLI commands and WebUI.
In the CLI
Use the following command to enable or disable the mDNS or DLNA for an AirGroup service:
airgroup [mdns|dlna] enable|disable
Both mDNS and DLNA are disabled by default.
Use the following command to view the status of mDNS and DLNA features:
#show airgroup status
Viewing AirGroup Global Setting on Controller
In the WebUI
To view the global setting of AirGroup in the controller WebUI:
1. Navigate to Configuration > Advanced Services > AirGroup.
2. Select the AirGroup Settings tab to view the AirGroup Global Setting in the controller.
Dell Networking W-Series ArubaOS 6.5.x | User Guide AirGroup |
1007