Users Guide

6 Dell Networking W-Series ArubaOS 6.4.x | Quick Start Guide
Enter the VLAN 1 interface IPv6
address [2000::1]:
NOTE: This prompt is not
applicable if the switch role is
branch.
The controller takes its IP address from VLAN 1 and uses this IP address to communicate with
other controllers and with APs. Supported subnets are: Global Unicast: 2000::/3, Unique local
unicast: fc00::/7
Enter an IPv6 VLAN 1 interface IP address, or press Enter without specifying an IP address to
use the default address 2000::1.
Enter VLAN 1 interface IPv6
prefix length [64]:
NOTE: This prompt is not
applicable if the switch role is
branch.
Enter a value from 0 to 128 to define an IPv6 VLAN 1 interface IP prefix length, or press Enter
without specifying a prefix length to use the default value of 64.
Enter IPv6 default gateway
[none]:
NOTE: This prompt is not
applicable if the switch role is
branch.
This optional value is usually the IP address of the interface on the upstream switch or router
to which you will connect the controller. The default gateway and the VLAN 1 IP address need
to be in the same network. Enter an IPv6 gateway IP address to configure this setting, or press
Enter to continue without specifying an IP gateway.
Enter Branch Master switch IP
address
NOTE: This prompt is
applicable only if the switch
role is branch.
Enter the IP address of the branch master controller. Enter branch master switch IP address or
FQDN
Enter Branch wired uplink port
[GE 1/0]
NOTE: This prompt is
applicable only if the switch
role is branch.
Its not value 1 or 0, value should be 1/0 or 0/0/0 or any port based on the
controller platform
Enter Branch wired-vlan Type
(pppoe|dhcp|static) [static]
NOTE: This prompt is
applicable only if the switch
role is branch.
Enter the type of the branch wired VLAN.
This controller is restricted to
Country code US for United
States, please confirm (yes|no)
If your controller has a country code that restricts its usage, enter yes to confirm this code.
Enter Time Zone Enter the time zone for the controller, or press Enter to select the default time zone.
Enter Time in UTC Enter the current time in UTC format, or press Enter to select the default time.
Enter Date (MM/DD/YYYY) Enter the current date, or press Enter to select the default date.
Enter Password for admin login
(up to 32 chars)
NOTE: This prompt is not
applicable if the switch role is
branch.
Enter a password to allow the admin user to login to the controller WebUI, CLI and console
interfaces. This password can be up to 32 alphanumeric characters long.
Enter Password for enable
mode (up to 15 chars)
NOTE: This prompt is not
applicable if the switch role is
branch.
Enter a password for the admin user to access Enable mode in the controller WebUI, CLI and
console interfaces. This password can be up to 15 alphanumeric characters.
Do you wish to shutdown all the
ports (yes|no)? [no]
NOTE: This prompt is not
applicable if the switch role is
branch.
Enter yes to shut down all ethernet ports on the controller, or press Enter to allow all ports to
remain active.
Table 4 Serial Console Configuration Dialog (Continued)
Console Prompt Description