Users Guide

Summary
Table Name
Basic View Information Advanced View Information
Device Info l Type: AP device/model type.
l Name: Name assigned to the AP.
l Wired MAC address: MAC address
of the wired port.
l Serial #: AP serial number.
l Tunnel IP address: IP address of
the tunnel between the AP and
controller.
l Software Version: Software version
currently running on the AP.
l Uptime: Amount of time the AP has
been active since it was last reset.
l Master: IP address of the master
controller.
l lms: IP address of the local
controller.
N/A
Uplink Info The Uplink Info table can display some
or all of the following information for
your remote AP, depending upon
whether a link is active and the number
of links supported by the AP.
Active uplink information, including:
l Interface name
l Port speed
l IP address
Standby link information, including:
l Name (3G)
l Device connected (yes/no)
l Provisioned (yes/no)
l IP address
l Device
l User
l Password
N/A
Multihoming on remote AP (RAP)
You can uplink a RAP as an Ethernet or a USB based modem. These uplinks can be used as a backup link if the
primary link fails. The uplink becomes active based on the order of priority configured on the RAP. The RAP
switches back to the primary link when the primary connection is restored.
For information on provisioning the RAP using the USB based modem, see Provisioning 4G USB Modems on
Remote Access Points on page 760.
Dell Networking W-Series ArubaOS 6.4.x | User Guide Remote Access Points | 732