Users Guide

681 | RSTP Dell Networking W-Series ArubaOS 6.4.x| User Guide
Feature Default Value/Range
Point-to-
Point
Set the interface as a point-to-point link
Default : Enabled
In the CLI
Change the default configurations using the command line interface:
(host) (config-if)#spanning-tree
cost Change an interface's spanning tree path cost
point-to-point Set interface as point-to-point link
port-priority Change an interface's spanning tree priority
portfast Allow a change from blocking to forwarding
Monitoring RSTP
Statistics for point-to-point, role, BPDU, and other information can be viewed in the WebUI (see
Figure 85).
Figure 85 Monitoring RSTP
Troubleshooting RSTP
The following commands can be used to troubleshoot RSTP:
l The show spantree command (config mode) displays the root and bridge information, verifying that they
are correct. The port/interface information (e.g. state, role, etc.) is also displayed to make sure that the state
and role information correspond with each other. For more details and examples on the show spantree
command, refer to show spantree in the ArubaOS Command-Line Interface Reference Guide.