Deployment Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series 334/335 Access Points

Dell Networking 330 Series Access Points

Regulatory Compliance and Safety Information Guide

0511909-01 | May 2016 1

Introduction

This document contains domestic and international regulatory compliance and safety information for 330 Series. To ensure that this device complies with the

regulatory standards for your region, please refer to the sections below.

 Electrical and Environmental Specifications

 Regulatory Information

 Proper Disposal of Dell Equipment

Electrical and Environmental Specifications

For additional specifications on this product, please refer to the product data sheet at dell.com.

Electrical

 Ethernet:

 ENET0: 100/1000/2500 BaseT auto-sensing Ethernet RJ45 interface

 ENET1: 100/1000 Base-T auto-sensing Ethernet RJ45 interface

 IEEE 802.3u (100 Base-T). IEEE 802.3ab (1000 Base-T)

 Power over Ethernet IEEE 802.3at 56VDC (nominal) and 802.3af 48VDC (maximum).

 Power:

 48VDC power interference, support powering through an AC-to-DC power adapter (AP-AC-48V36B)

 Maximum power consumption (excluding USB): 20W (PoE) or 18.5W (DC)

Environmental

 Operating:

 Temperature: 0°C to +50°C (+32°F to +122°F)

 Humidity: 5% to 93% non-condensing

 Storage and transport:

 Temperature: -40°C to +70°C (40°F to +158°F)

CAUTION: All Dell access points should be professionally installed by a certified technician. The installer is responsible for ensuring that

grounding is available and meets applicable national and electrical codes.

ATTENTION: Tous les points d'accès Dell doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer que

l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.

NOTE: If a power adapter other than the Dell-approved adapter is used in the US or Canada, it should be NRTL listed, without an output rated

48VDC, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a standard power receptacle in the US and Canada.

Summary of content (4 pages)

PAGE 1
Dell Networking 330 Series Access Points Regulatory Compliance and Safety Information Guide Introduction This document contains domestic and international regulatory compliance and safety information for 330 Series. To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.
PAGE 2
Regulatory Information The following regulatory model names apply to the 330 Series:  AP-334/IAP-334: APIN0334  AP-335/IAP-335: APIN0335 NOTE: For country specific restrictions and additional regulatory and safety guidelines, refer to the Dell Networking W-Series Safety, Environmental and Regulatory Information document included with Dell controllers and Instant access points.
PAGE 3
Users are advised that high power Radars are allocated as primary users of the bands 5250-5350 MHz and 5650-5850 MHz and these Radars could cause interference and/or damage to Licensed Exempt WLAN devices. CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
PAGE 4
RF Warning 해당무선설비는 전파혼신의 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다 . Proper Disposal of Dell Equipment Dispose of Dell products per local regulation. For the most current information about Global Environmental Compliance and Dell products, visit dell.com. Waste of Electrical and Electronic Equipment Dell products at end of life are subject to separate collection and treatment in the EU Member States, Norway, and Switzerland and therefore are marked with the symbol shown at the left (crossed-out wheelie bin).