Concept Guide

393 | IAP-VPN Deployment Scenarios Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide
Configuration Steps CLI Commands UI Procedure
(ap)(Access Rule "wireless-ssid-contractor")# rule
10.16.0.0 255.255.0.0 match any any any permit
(ap)(Access Rule "wireless-ssid-contractor")# rule
any any match any any any src-nat
NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and
propagating changes across the W-IAP cluster.
Table 77: W-IAP Configuration for Scenario 3—IPSec: Multiple Datacenter Deployment
AP Connected Switch Configuration
Client VLANs defined in this example must be opened on the upstream switches in multiple AP deployments, as
client traffic from slave to master is tagged with the client VLAN.
Datacenter Configuration
For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 244.
The following OSPF configuration is required on the controller to redistribute IAP-VPN routes to upstream
routers.
(host)(config) # router ospf
(host)(config) # router ospf router-id <ID>
(host)(config) # router ospf area 0.0.0.0
(host)(config) # router ospf redistribute rapng-vpn