Concept Guide

4. Select the Access Point from the Access Point to Convert drop-down list.
5. Click Convert Now to complete the conversion. The W-IAP now operates in the stand-alone mode.
Converting a W-IAP using CLI
To convert a W-IAP to a remote AP or campus AP:
(Instant AP)# convert-aos-ap <mode> <controller-IP-address>
To convert a W-IAP to a stand-alone W-IAP or to provision a W-IAP in the cluster mode:
(Instant AP)# swarm-mode <mode>
Resetting a Remote AP or Campus AP to a W-IAP
The reset knob located on the rear of a W-IAP can be used to reset the W-IAP to factory default settings.
To reset a W-IAP, perform the following steps:
1. Turn off the W-IAP.
2. Press and hold the reset knob using a small and narrow object such as a paperclip.
3. Turn on the W-IAP without releasing the reset knob. The power LED flashes within 5 seconds indicating that
the reset is completed.
4. Release the reset knob. The W-IAP reboots with the factory default settings.
Rebooting the W-IAP
If you encounter any problem with the W-IAPs, you can reboot all W-IAPs or a selected W-IAP in a network
using the Instant UI. To reboot a W-IAP:
1. Click Maintenance in the Instant main window.
2. Click the Reboot tab.
Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide W-IAP Maintenance | 359