Concept Guide

84 | enet-vlan Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
enet-vlan
enet-vlan <vlan-ID>
no…
Description
This command configures a VLAN for Ethernet connections.
Syntax
Parameter Description Range Default
enet-vlan <vlan-ID>
Configures VLAN for the upstream switch to
which the AP is connected.
0–4093 1
no…
Removes the configuration.
— —
Usage Guidelines
Use this command to configure VLAN settings for upstream switch to which the AP is connected. By default,
the value is set to 1. The VLAN setting configured by this command is used for restricting the AP from sending
out tagged frames to clients connected on the SSID that has the same VLAN as the native VLAN of the
upstream switch, to which the W-IAP is connected.
Example
The following example configures a non-default VLAN value for the Ethernet ports:
(Instant AP)(config)# enet-vlan 200
(Instant AP)(config)# end
(Instant AP)# commit apply
Command History
Version Description
Dell Networking W-Series Instant 6.2.1.0-
3.3
This command is introduced.
Command Information
W-IAP Platform Command Mode
All platforms
Configuration mode