Concept Guide

620 | wlan ssid-profile Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
Command/Parameter Description Range Default
system response to the broadcast probe
requests sent by clients to search for the
available SSIDs and ignores the probe request if
required,
mac-authentication
Enables MAC authentication for clients that use
this SSID profile.
— Disabled
mac-authentication-
delimiter <delim>
Allows you to set a delimiter that can be used in
the MAC address string for MAC authentication.
You can specify colon or dash for delimiter. If the
delimiter is not specified, the MAC address in the
xxxxxxxxxxxx format is used. If you specify colon
for the delimiter, the MAC addresses in the
xx:xx:xx:xx:xx:xx format are used.
colon or dash —
mac-authentication-
upper-case
Enables the W-IAP to use uppercase letters in
MAC address string for MAC authentication.
— —
max-authentication-
failures <limit>
Configures the maximum number of
authentication failures to dynamically blacklist
the users.
The users who exceed the number of
authentication failures configured through this
command are dynamically blacklisted.
— —
max-clients-threshold
<threshold>
Configures the maximum number of clients for a
BSSID on a WLAN.
0-255 64
multicast-rate-
optimization
Allows the W-IAP to select the optimal rate for
sending broadcast and multicast frames based
on the lowest of unicast rates across all
associated clients.
When enabled, the multicast traffic can be sent at
the rate of 1-24 Mbps. The default rate for
sending frames for 2.4 GHz is 1 Mbps and 5.0
GHz is 6 Mbps.
— Disabled
mpdu-agg-disable
Disables MAC Protocol Data Unit (MPDU)
aggregation
— —
okc
Enables opportunistic key caching (OKC).
— —
okc-disable
Disables opportunistic key caching (OKC). — —