Concept Guide

204 | rf dot11a-radio-profile Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
Parameter Description Range Default
with normal access service to clients, while
performing additional function of monitoring
RF interference (from both neighboring APs
and non Wi-Fi sources such as, microwaves
and cordless phones) on the channel they are
currently serving clients.
no…
Removes the configuration. — —
Usage Guidelines
Use this command to create a 5.0 GHz radio profile on a W-IAP.
Example
The following example configures the 5 GHz radio profile:
(Instant AP)(config)# rf dot11a-radio-profile
(Instant AP)(RF dot11a Radio Profile)# beacon-interval 100
(Instant AP)(RF dot11a Radio Profile)# legacy-mode
(Instant AP)(RF dot11a Radio Profile)# dot11h
(Instant AP)(RF dot11a Radio Profile)# interference-immunity 3
(Instant AP)(RF dot11a Radio Profile)# max-tx-power 33
(Instant AP)(RF dot11a Radio Profile)# min-tx-power 10
(Instant AP)(RF dot11a Radio Profile)# max-distance 600
(Instant AP)(RF dot11a Radio Profile)# csa-count 2
(Instant AP)(RF dot11a Radio Profile)# spectrum-monitor
(Instant AP)(RF dot11a Radio Profile)# end
Command History
Version Description
Dell Networking W-Series Instant 6.4.3.1-4.2 The max-tx-power and min-tx-power parameters were
added.
Dell Networking W-Series Instant 6.3.1.1-4.0 This command is modified.
Dell Networking W-Series Instant 6.2.1.0-3.3
This command is introduced.
Command Information
W-IAP Platform Command Mode
All platforms
Configuration mode and RF dot11a Radio Profile configuration
sub-mode