Deployment Guide

6 Dell Networking W-IAP228 Wireless Instant Access Point | Installation Guide
Using the AP-220-MNT-W1 Mounting Kit
The W-IAP228 Instant access point can be installed on a wall using the AP-220-MNT-W1 mounting kit.
1. Begin by attaching the wall mount adapter to the wall.
a. Install any necessary wall anchors. Wall anchors are not included in the IAP package or mounting kit.
b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated screw
points.
c. Insert the screws to secure the mounting bracket. Screws are not included in the IAP package or mounting
kit.
Figure 5 Attaching the Adapter to a Wall
Figure 6 Attaching the Adapter to a Wall (Alternate)
2. Attach necessary cables and/or antennas to the IAP.
3. Attach the IAP to the secured mounting adapter as shown in Figure 7.
NOTE: The W-IAP228 Instant access point does not ship with any mounting kit. The AP-220-MNT-W1 mounting kit is available as
an accessory and must be ordered separately.
AP-220_11
AP-220_14