Concept Guide
Table Of Contents
- About this Guide
- About Instant
- Setting up a W-IAP
- Automatic Retrieval of Configuration
- Instant User Interface
- Initial Configuration Tasks
- Customizing W-IAP Settings
- Modifying the W-IAP Host Name
- Configuring Zone Settings on a W-IAP
- Specifying a Method for Obtaining IP Address
- Configuring External Antenna
- Configuring Radio Profiles for a W-IAP
- Configuring Uplink VLAN for a W-IAP
- Changing the W-IAP Installation Mode
- Changing USB Port Status
- Master Election and Virtual Controller
- Adding a W-IAP to the Network
- Removing a W-IAP from the Network
- VLAN Configuration
- IPv6 Support
- Wireless Network Profiles
- Configuring Wireless Network Profiles
- Configuring Fast Roaming for Wireless Clients
- Configuring Modulation Rates on a WLAN SSID
- Multi-User-MIMO
- Management Frame Protection
- Disabling Short Preamble for Wireless Client
- Editing Status of a WLAN SSID Profile
- Editing a WLAN SSID Profile
- Deleting a WLAN SSID Profile
- Wired Profiles
- Captive Portal for Guest Access
- Understanding Captive Portal
- Configuring a WLAN SSID for Guest Access
- Configuring Wired Profile for Guest Access
- Configuring Internal Captive Portal for Guest Network
- Configuring External Captive Portal for a Guest Network
- Configuring Facebook Login
- Configuring Guest Logon Role and Access Rules for Guest Users
- Configuring Captive Portal Roles for an SSID
- Configuring Walled Garden Access
- Authentication and User Management
- Managing W-IAP Users
- Supported Authentication Methods
- Supported EAP Authentication Frameworks
- Configuring Authentication Servers
- Understanding Encryption Types
- Configuring Authentication Survivability
- Configuring 802.1X Authentication for a Network Profile
- Enabling 802.1X Supplicant Support
- Configuring MAC Authentication for a Network Profile
- Configuring MAC Authentication with 802.1X Authentication
- Configuring MAC Authentication with Captive Portal Authentication
- Configuring WISPr Authentication
- Blacklisting Clients
- Uploading Certificates
- Roles and Policies
- DHCP Configuration
- Configuring Time-Based Services
- Dynamic DNS Registration
- VPN Configuration
- IAP-VPN Deployment
- Adaptive Radio Management
- Deep Packet Inspection and Application Visibility
- Voice and Video
- Services
- Configuring AirGroup
- Configuring a W-IAP for RTLS Support
- Configuring a W-IAP for Analytics and Location Engine Support
- Managing BLE Beacons
- Clarity Live
- Configuring OpenDNS Credentials
- Integrating a W-IAP with Palo Alto Networks Firewall
- Integrating a W-IAP with an XML API Interface
- CALEA Integration and Lawful Intercept Compliance
- Cluster Security
- W-IAP Management and Monitoring
- Uplink Configuration
- Intrusion Detection
- Mesh W-IAP Configuration
- Mobility and Client Management
- Spectrum Monitor
- W-IAP Maintenance
- Monitoring Devices and Logs
- Hotspot Profiles
- ClearPass Guest Setup
- IAP-VPN Deployment Scenarios
- Acronyms and Abbreviations

414 | IAP-VPN Deployment Scenarios Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide
Term Definition
hotspot A WLAN node that provides Internet connection and virtual private
network (VPN) access from a given location. A business traveler, for
example, with a laptop equipped for Wi-Fi can look up a local hot spot,
contact it, and get connected through its network to reach the Internet
and their own company remotely with a secure connection. Increasingly,
public places, such as airports, hotels, and coffee shops are providing
free wireless access for customers.
IEEE 802.11 standards The IEEE 802.11 is a set of standards that are categorized based on the
radio wave frequency and the data transfer rate.
POE Power over Ethernet (PoE) is a method of delivering power on the same
physical Ethernet wire used for data communication. Power for devices
is provided in one of the following two ways:
l Endspan— The switch that an AP is connected for power supply.
l Midspan— A device can sit between the switch and APs
The choice of endspan or midspan depends on the capabilities of the
switch to which the W-IAP is connected. Typically if a switch is in place
and does not support PoE, midspan power injectors are used.
PPPoE Point-to-Point Protocol over Ethernet (PPPoE) is a method of connecting
to the Internet typically used with DSL services where the client connects
to the DSL modem.
QoS Quality of Service (QoS) refers to the capability of a network to provide
better service to a specific network traffic over various technologies.
RF Radio Frequency (RF) refers to the portion of electromagnetic spectrum
in which electromagnetic waves are generated by feeding alternating
current to an antenna.
TACACS Family of protocols that handle remote authentication and related
services for network access control through a centralized server.
TACACS+ Derived from TACACS but an entirely new and separate protocol to
handle AAA services. TACACS+ uses TCP and is not compatible with
TACACS. Because it encrypts password, username, authorization, and
accounting, it is less vulnerable than RADIUS.
VPN A Virtual Private Network (VPN) network that uses a public
telecommunication infrastructure, such as the Internet, to provide
remote offices or individual users with secure access to their
organization's network. A VPN ensures privacy through security
procedures and tunneling protocols such as the Layer Two Tunneling
Protocol ( L2TP ). Data is encrypted at the sending end and decrypted at
the receiving end.
Table 88: List of Terms