Concept Guide

show aaa state log
show aaa state log [info]
Description
Display global log files for AAA events.
Syntax
Parameter Description
info
This parameter displays debugging information for internal use only.
Usage Guidelines
If you have enabled per-user logging using the aaa log command, the output of this command displays global
AAA log files for events that are not triggered by individual user authentication, such as AP authentication and
the initial pre-authentication processes that occur before a client authenticates to the controller.
To display log files for events triggered by a specific user, use the command show user or show ipv6 user-
table ip <ipv6-addr> log.
Example
The example below shows a partial list of the global log files displayed by the show aaa state log command..
(host) #show aaa state log
1: At Thu Apr 11 10:41:27: [L] Type cert-downloaded * id 0 len 0, bssid
00:00:00:00:00:00 | mac: 00:00:00:00:00:00
2: At Thu Apr 11 10:43:17: [L] Type ap-up * id 0 len 0, bssid
6c:f3:7f:5f:2c:b0 | mac: 00:00:00:00:00:00
3: At Thu Apr 11 10:43:17: [L] Type ap-up * id 0 len 0, bssid
6c:f3:7f:5f:2c:a0 | mac: 00:00:00:00:00:00
4: At Thu Apr 11 10:43:50: [L] Type station-term-start * id 10 len 0, bssid
6c:f3:7f:5f:2c:a0 | mac: 50:a4:c8:bd:be:41
5: At Thu Apr 11 10:43:50: [L] Type station-data-ready_ack * id 10 len 0, bssid
00:00:00:00:00:00 | mac: 50:a4:c8:bd:be:41
Related Commands
Parameter Description
aaa log
Issue this command to enable per-user logging.
show user
show ipv6 user-table
Display log files for authentication events triggered by a specific IPv4 or IPV6
user.
Command History
This command was introduced in ArubaOS 6.3.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show aaa state log | 876