Concept Guide

Dell Networking W-Series ArubaOS 6.5.x | Reference Guide The ArubaOS Command-Line Interface | 4
The ArubaOS Command-Line Interface
The Dell Networking W-Series ArubaOS 6.5.x command-line interface (CLI) allows you to configure and manage
Dell controllers. The CLI is accessible from a local console connected to the serial port on the controllers or
through a Telnet or Secure Shell (SSH) session from a remote management console or workstation.
Telnet access is disabled by default. To enable Telnet access, enter the telnet CLI command from a serial connection
or an SSH session, or in the WebUI navigate to the Configuration > Management > General page.
What’s New in ArubaOS 6.5.x
This section lists the commands introduced, modified, or deprecated in ArubaOS 6.5.x.
Commands in ArubaOS 6.5.0.0
New Commands
The following new commands are introduced in ArubaOS 6.5.0.0:
Command Description
ap consolidated-provision
info
This command stores the consolidated AP-provisioned information of
all APs connected to a controller in the ap_provision_info.txt file.
block-redirect-url This command redirects the user session to an external splash page
when it encounters a webcc deny policy.
crypto-local isakmp allow-
via-subnet-routes
This command allows the controller to accept the subnets published
by VIA-clients. By default, this feature is disabled.
ip reputation This command blocks connectivity to IP addresses classified as
malicious.
ip probe health-check
This command configures WAN health-check ping-probes for measuring
WAN availability and latency on branch controller uplinks.
ntp standalone This command enables or disables controller to act as NTP server.
show ap consolidated-
provision info
This command displays the consolidated AP-provisioned information
for an access point connected to the controller.
show ip-reputation This command displays the IP Reputation status of various services.
show ip health-check Display the health-check status of the uplink interfaces of a branch-
office controller.