Concept Guide

Parameter Description Range Default
deny-inter-user-bridging
Prevents the forwarding of
Layer2 traffic between wired or
wireless users. You can
configure user role policies that
prevent Layer3 traffic between
users or networks but this does
not block Layer2 traffic. This
option can be used to prevent
traffic, such as Appletalk or IPX
from being forwarded. If
enabled, traffic (all non-IP
traffic) to untrusted port or
tunnel is also blocked.
— disable
d
deny-inter-user-traffic
Denies downstream traffic
between users in a wireless
network (untrusted users) by
disallowing layer2 and layer3
traffic. This parameter does not
depend on the deny-inter-
user-bridging parameter
being enabled or disabled.
— disable
d
deny-source-routing
Disallows forwarding of IP frames
with source routing with the
source routing options set.
— disabled
disable-ftp-server
Disables the FTP server on the
controller. Enabling this option
prevents FTP transfers.
Enabling this option could
cause APs to not boot up. You
should not enable this option
unless instructed to do so by a
Dell representative.
— disable
d
disable-stateful-h323-
processing
Disables stateful H.323
processing.
— disable
d
disable-stateful-sccp-processing
Disables SCCP processing. — disable
d
disable-stateful-sip-processing
Disables monitoring of
exchanges between a voice
over IP or voice over WLAN
device and a SIP server. This
option should be enabled only
when there is no VoIP or
VoWLAN traffic on the network.
— disable
d
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide firewall | 376