Concept Guide

apdisconnect
apdisconnect {ap-name <name>|bssid <bssid>|ip-addr <ipaddr>}
Description
This command disconnects a mesh point from its parent.
Syntax
Parameter Description
ap-name
Specifies the name of the parent AP.
bssid
Specifies the BSSID of the parent AP.
ip-addr
Specifies the IP address of the parent AP.
Usage Guidelines
Each mesh point learns about the mesh portal from its parent (a mesh node that is part of the path to the
mesh portal). This command directs a mesh point to disassociate from its parent. The mesh point will attempt
to associate with another neighboring mesh node, if available. The old parent is not eligible for re-association
for 60 seconds after disconnection.
Example
The following command disconnects a specific mesh point from its parent:
(host) (config) #apdisconnect ap-name meshpoint1
Related Commands
Command Description Mode
apconnect This command connects a mesh point to a new specified
parent.
Enable or Config mode
Command History
This command was introduced in ArubaOS 3.2
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide apdisconnect | 233