Concept Guide
Parameter Description Range Default
max-request-re
tries
Maximum number of times to
retry AP-generated requests,
including keepalive messages.
After the maximum number of
retries, the AP either tries the
IP address specified by the
bkup-lms-ip (if configured) or
reboots.
1-65535 10
mcast-aggr
Enable multicast aggregation
at AP.
— disabled
mcast-aggr-allowed-vlan
<vlan-list>
Enable list of VLANs where
APmulticast aggregation is
allowed.
— disabled
mtu
MTU, in bytes, on the wired
link for the AP.
1024-1578 —
native-vlan-id
Native VLAN for bridge mode
virtual APs (frames on the
native VLAN are not tagged
with 802.1q tags).
— 1
no
Negates any configured
parameter.
— —
number-ipsec-retries
The number of times the AP
will attempt to recreate an
IPsec tunnel with the master
controller before the AP will
reboot. A value of 0 disables
the reboot.
1-1000 85
rap-bw-total
This is the total reserved
uplink bandwidth (in Kilobits
per second).
— —
rap-bw-resv-1
Session ACLs with uplink
bandwidth reservation in
kilobits per second. You can
specify up to three session
ACLs to reserve uplink
bandwidth. The sum of the
three uplink bandwidths
should not exceed the rap-
bw-total value.
— —
rap-bw-resv-2
rap-bw-resv-3
rap-dhcp-
default-router
IP address for the default
DHCP router.
— 192.168.11.1
rap-dhcp-dns-
server
IP address of the DNS server. — 192.168.11.1
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap system-profile | 218