Concept Guide

Parameter Description Default Range
no
Negates any configured parameter. — —
pppoe-passwd
Point-to-Point Protocol over Ethernet (PPPoE) password
for the AP.
— —
pppoe-service-
name
PPPoE service name for the AP. — —
pppoe-user
PPPoE username for the AP. — —
remote-ap
Specifies that the profile is to be associated with a
remote AP using certificates.
— —
reprovision
Provisions one or more APs with the values in the
provisioning profile.
— —
reset-bootinfo
Restores factory default provisioning parameters to the
specified AP.
NOTE: This parameter can only be used on the master
controller.
— —
uplink-vlan <uplink-vlan>
If you configure an uplink VLAN on an AP connected to a
port in trunk mode, the AP sends and receives frames
tagged with this VLAN on its Ethernet uplink.
By default, an AP has an uplink vlan of 0, which disables
this feature.
NOTE: If an AP is provisioned with an uplink VLAN, it
must be connected to a trunk mode port or the AP’s
frames will be dropped.
0 (
disable
d) to
4095
0
usb-dev
The USB device identifier. — —
usb-dial
The dial string for the USB modem. This parameter only
needs to be specified if the default string is not correct.
— —
usb-init
The initialization string for the USB modem. This
parameter only needs to be specified if the default string
is not correct.
— —
usb-modeswitch
-v <default_vendor>
-p <default_product>
-V <target_vendor>
-P <target_product>
-M <message_content>
USB cellular devices on remote APs typically register as
modems, but may occasionally register as a mass-
storage device. If a remote AP cannot recognize its USB
cellular modem, use the usb-modeswitch command to
specify the parameters for the hardware model of the
USB cellular data-card.
NOTE: You must enclose the entire modeswitch
parameter string in quotation marks.
— —
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap provisioning-profile | 191