Concept Guide

1570| show interface port-channel Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
Hardware is....
Hardware interface type.
address is...
MAC address of the hardware interface.
Description
The port type, name, and connector type. If the LAG
is created by LACP, it is indicated as shown in the
display output above. If the LAG is created by LACP,
you can not statically add or delete any ports under
that port channel. All other commands are allowed.
If LACP is not shown, then the LAG is created by
static configuration.
Spanning Tree is...
Spanning tree status on the specified port-channel.
VLAN membership
Number of VLANs the specified port-channel is
associated with.
Switchport priority
Switchport priority of the specified port-channel.
Jumbo Support is...
Displays the status of jumbo frame on a port channel.
Last clearing of “show interface counters”
Time since “show interface counters” was cleared.
Below the time, all current counters related to the
specified port are listed.
Port-channel 0 is...
Whether or not this port-channel is trusted.
#show interface port-channel 0 access-group
Port-Channel 0:
Port-Vlan Session ACL
---------------------
SessionACL Vlan Status
---------- ---- ------
The output of this command includes the following parameters:
Parameter Description
SessionACL
Session ACL name.
Vlan
VLAN number.
Status
ACL status.
#show interface port-channel 0 counters
Port InOctets InUcastPkts InMcastPkts InBcastPkts
PC 0: 0 0 0 0
Port OutOctets OutUcastPkts OutMcastPkts OutBcastPkts