Concept Guide
show ap debug port status
show ap debug port status {ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>|ip6-addr <ip6-
addr>}
Description
Shows the status of the AP's wired ports.
Syntax
Parameter Description
ap-name <ap-name>
Name of the AP.
bssid <bssid>
BSSID of the AP.
ip-addr <ip-addr>
IP address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
Examples
The output of the command displays the wired port status of an APnamed LocalAP1. In this example, the
output is divided into multiple sections to fit better on the pages of this document. In the actual command-line
interface, it appears in a single long table.
(host) #show ap debug port status ap-name LocalAP1
AP "LocalAP1" Port Status
-----------------------------
Port MAC Type Forward Mode Admin Oper Speed Duplex 802.3az PoE STP
Portfast TX-Packets TX-Bytes RX-Packets RX-Bytes
---- --- ---- ------------ ----- ---- ----- ------ ------- --- ---
-------- ---------- -------- ---------- --------
0 9c:1c:12:c0:ab:40 GE N/A enabled up 1 Gb/s full disabled N/A N/A
N/A 613192 318529911 963948 116679839
1 9c:1c:12:c0:ab:41 GE tunnel enabled down N/A N/A N/A N/A N/A
N/A 0 0 0 0
Command History
Version Modification
ArubaOS 6.2 Command introduced.
ArubaOS 6.3 A new column STP displays the spanning tree state of the wired port.
The ip6-addr parameter was introduced.
ArubaOS 6.5 A new column Portfast displays the Portfast state of the wired port.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap debug port status | 1109