Concept Guide

588 | wired-port-profile Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
Command/Parameter Description Range Default
comma separated digits or
ranges 1,2,5 or 1-4, or all.
auth-server <name>
Configures the authentication
server for the wired profile.
— —
captive-portal{<type>
[exclude-uplink <types>]
|external[exclude-uplink
<types>| profile <name>
[exclude-uplink <types>]]}
Enables internal or external
captive portal authentication for
the wired profile users.
You can also disable redirection
to the captive portal based on the
type of current uplink.
If the external captive profiles are
created, you can specify the
profile name by using the
external and profile keywords
and associated parameters.
— —
content-filtering
Enables content filtering — —
dot1x
Enables 802.11X authentication
for the Wired profile users
— Disabled
duplex <duplex>
Assigns a value for duplexing
client traffic based on the
capabilities of the client, the AP,
and the cable. You can specify
full, half, or auto.
full, half, auto auto
inactivity-timeout
<interval>
Configures a timeout value for
the inactive client sessions.
When a client session is inactive
for the specified duration, the
session expires and the clients
are required to log in again.
60-86400
seconds
1000 seconds
l2-auth-failthrough
Allows the clients to use 802.1X
authentication when MAC
authentication fails.
— Disabled
mac-authentication
Enables MAC authentication — Disabled
native-vlan <vlan>
Configures a value for Native
VLAN. A VLAN that does not have
a VLAN ID tag in the frames is
1-4093 —