Concept Guide

uplink
uplink
enforce {ethernet| cellular |wifi | none}
failover-internet
failover-internet-check-timeout
failover-internet-pkt-lost-cnt <count>
failover-internet-pkt-send-freq <frequency>
failover-vpn-timeout <seconds>
preemption
uplink-priority {cellular <priority> | ethernet <priority>| [port <Interface-number>
<priority>]|wifi <priority>}
no…
no uplink
Description
This command configures uplink connections.
Syntax
Parameter Description Range Default
uplink
Enables the uplink
configuration sub-mode.
— —
enforce {ethernet|cellular
|wifi | none}
Enforces the specified uplink
connection.
You can specify the following
types of uplink:
l ethernet
l cellular
l wifi
l none
ethernet,
cellular,
wifi,
none
None
failover-internet
Enables uplink switchover
based on the availability of the
Internet.
When enabled, the W-IAP
continuously sends ICMP
packets to some well-known
Internet servers. If the request
is timed out due to a bad uplink
connection or uplink interface
failure, and the public Internet
is not reachable from the
current uplink, the W-IAP
switches to a different
connection.
— Disabled
failover-internet-check-timeout
The number of seconds after
which the Internet based uplink
verification times out.
0-3600 10
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide uplink | 557