Concept Guide

530 | show vpn Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
show vpn
show vpn {config|status|tunnels}
Description
This command displays the status and configuration details for VPN-enabled W-IAPs.
Syntax
Parameter Description
config
Displays configuration details for the VPN-enabled W-IAPs.
status
Displays the status of the VPNconnections enabled on a W-IAP.
tunnels
Displays the IAP-VPN retry counter statistics.
Example
The following example shows the output displayed for show vpn config command:
Concentrator
------------
Type Value
---- -----
VPN Primary Server
VPN Backup Server
VPN Preemption disable
VPN Fast Failover disable
VPN Hold Time 600
VPN Monitor Pkt Send Freq 5
VPN Monitor Pkt Lost Cnt 2
VPN Ikepsk
VPN Username
VPN Password 95a5624fbf08dfb3e794ac2c6686e330
GRE outside vpn disable
GRE Server
GRE IP Address 0.0.0.0
GRE Type 1
GRE Per AP Tunnel disable
Reconnect User On Failover disable
Reconnect Time On Failover 60
Routing Table
-------------
Destination Netmask Gateway Type
----------- ------- ------- ----
The output displayed for this command provides information on theparameters configured for the VPN
concentrator.
For more information on the VPN configuration parameters, see the following commands:
l vpn primary
l vpn backup
l vpn preemption
l vpn fast-failover
l vpn gre-outside
l vpn hold-time