Concept Guide

Command/Parameter Description Range Default
2—Radio-
based
3—Channel
and Radio
based
g-channels <g-channel>
Configures 2.4 GHz channels. — —
snr-thresh <snr>
The snr value of the Client RSSI must be
higher than the current AP for a potential
target AP.
0-100 10
good-snr <snr>
The W-IAPs with a RSSI higher than the
specified good-snr value will be
considered as a potential target W-IAP.
0-100 30
bad-snr <snr>
The clients with an SNR value below the
threshold value will be moved to a
potential target AP.
0-100 18
min-tx-power <power>
Sets the minimum transmission power.
This indicates the minimum Effective
Isotropic Radiated Power (EIRP). If the
minimum transmission EIRP setting
configured on an AP is not supported by
the AP model, this value is reduced to the
highest supported power setting.
0-127 dBm 18
max-tx-power <power>
Sets the highest transmit power levels for
the AP. If the maximum transmission EIRP
configured on an AP is not supported by
the AP model, the value is reduced to the
highest supported power setting.
NOTE: Higher power level settings may
be constrained by local regulatory
requirements and AP capabilities.
0-127 dBm 127
scanning
Allows the W-IAPs to scan other channels
for RF Management and Wireless
Intrusion Protection System enforcement.
— Disabled
vbr-entry-age <age>
Denotes the aging time for stable VBR
entries
1-3600 300
wide-bands {<none>| <all>|
<2.4>| <5>}
Allows administrators to configure 40
MHz. channels in the 2.4 GHz and 5.0 GHz
bands. 40 MHz channels are two 20 MHz
adjacent channels that are bonded
none, all,
2.4, and 5
5
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide arm | 41