Concept Guide

260 | show ap arm Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
172164890(-4108) 17697:0:100:100
The output of this command includes the following information:
Column Description
channel
Displays the list of channels configured on the W-IAP.
assign-time(ms)
Displays the time since W-IAP is assigned a channel.
scans-attempted
Indicates the number times a W-IAP has attempted to scan another channel.
scans-rejected
Displays the number of times a W-IAP was unable to scan a channel, because
the scan was halted due to other ARM settings.
dos-scans
Indicates the number of times services to a rogue device on a channel were
denied by a W-IAP.
flags
Indicates channel flags. For more information on channel flags, see the flag
description below the channel scan time table.
timer-tick
Indicates the time interval since the last scan.
Scan mode
Indicates if the scan mode enabled on the Wi-Fi interface.
channel
(under WIFI Scanning
State)
Indicates the channels available on the Wi-Fi interface.
current-scan-channel
Indicates the current channel scanned.
last-dos-channel
Indicates the last channel on which Denial of Service (DOS) was detected.
timer-milli-tick
Indicates the time in milliseconds since the Wi-Fi interface channels were
scanned.
next-scan-milli-tick
(jitter)
Indicates the next interval at which the scanning will begin.
scans (Tot:Rej:Eff
(%):Last intvl(%))
Provides a summary of the Wi-Fi scanning details.
Command History
Version Description
Dell Networking W-Series Instant 6.2.1.0-
3.3
This command is introduced.