Concept Guide

168 | l2tpv3 session Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
l2tpv3 session
l2tpv3 session <l2tpv3_session_profile>
cookie len <len_of_cookie> value <cookie_val>
default-l2-specific-sublayer
l2tpv3 tunnel <l2tpv3_tunnel_prof_to_associate>
tunnel-ip <local_ip_addr_tunnel> mask <tunnel_mask> vlan <tunnel_mgmt_vlan>
no…
Description
This command configures an Layer-2 Tunnel Protocol (L2TP) session profile.
Syntax
Parameter Description Range
Default
l2tpv3 session
<name>
Configures the session profile
name.
— —
cookie len <len_
of_cookie> value
<cookie_val>
Configures the length and
alphanumeric value for the
cookie.
Length: 4/8
If cookie length is 4, the
cookie value should
have exactly 8
hexadecimal
characters.
If cookie length is 8, the
cookie value should
have exactly 16
hexadecimal
characters
Not set.
default-l2-
specific-sublayer
Enables the default l2 specific
sublayer in the L2TPV3 session.
l2tpv3 tunnel
<l2tpv3_tunnel_
prof_to_
associate>
Selects the tunnel profile name
where the session will be
associated.
— —
tunnel <local_ip_
addr_tunnel> mask
<tunnel_mask>
vlan <tunnel_
mgmt_vlan>
Configures the local IP address,
network mask, and VLAN ID of
the tunnel.
2-4094 —
no…
Removes the configuration. — —
Usage Guidelines
Use this command to configure the session to carry the L2TP data.
Example
The following example configures the L2TPv3 session:
(Instant AP)(config) # l2tpv3 session test_session