Concept Guide

Configuration Steps CLI Commands UI Procedure
For WLAN SSID employee roles:
(ap)(config)# wlan access-rule wireless-ssid
(ap)(Access Rule "wireless-ssid")# rule any any match any any
any permit
Services
NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and
propagating changes across the W-IAP cluster.
Table 78: W-IAP Configuration for Scenario—GRE: Single Datacenter Deployment with No Redundancy
AP Connected Switch Configuration
Client VLANs defined in this example must be opened on the upstream switches in multiple AP deployments, as
client traffic from slave to master is tagged with the client VLAN.
Datacenter Configuration
For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 244.
The following GRE configuration is required on the controller:
(host)(config)# interface tunnel <Number>
(host)(config-tunnel)# description <Description>
(host)(config-tunnel)# tunnel mode gre <ID>
(host)(config-tunnel)# tunnel source <controller-IP>
(host)(config-tunnel)# tunnel destination <AP-IP>
(host)(config-tunnel)# trusted
(host)(config-tunnel)# tunnel vlan <allowed-VLAN>
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide IAP-VPN Deployment Scenarios | 397