Concept Guide

In the Instant UI
To configure Ethernet bridging:
1. On the Access Points tab, click the W-IAP to modify. The edit link is displayed.
2. Click the edit link. The edit window for modifying W-IAP details is displayed.
3. Click the Uplink tab.
4. Select Enable from the Eth0 Bridging drop-down list.
5. Click OK.
6. Reboot the W-IAP.
In the CLI
To configure Ethernet bridging:
Instant Access Point# enet0-bridging
Make the necessary changes to the wired-profile when eth0 is used as the downlink port. For more
information, see the Configuring a Wired Profile on page 119
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide Mesh W-IAP Configuration | 328