Concept Guide

256 | Adaptive Radio Management Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide
5.0 GHz Channels
----------------
Channel Status
------- ------
36 enable
40 enable
44 enable
48 enable
52 enable
56 enable
60 enable
64 enable
149 enable
153 enable
157 enable
161 enable
165 enable
36+ enable
44+ enable
52+ disable
60+ disable
149+ enable
157+ enable
36E enable
52E enable
149E enable
Client Match for Access Points in a Zone
When Client match is enabled, the decision to move a client from the home W-IAP to a target W-IAP is made at
the radio level. However, this proves inefficient when client match is enabled on an W-IAP or SSIDoperating in
a specific zone, it could result in the client being moved to a target W-IAP that does not have the same zone
specific SSID as the home W-IAP.
Starting from Instant 6.5.1.0-4.3.1.0, the decision to move a client from a home W-IAP to a target W-IAP will be
made at the SSID level instead of the radio level, by adding the SSIDname to the client match radio database.
Client Match will check if the same SSID (zone specific SSIDon Home W-IAP) is available on the target W-IAP
before it moves the client. This ensures that client match works as expected when zone settings are configured
on the W-IAP.
Additionally, the maximum clients threshold and the current associated client number of the SSID is added to
the client match radio database to prevent the clients from being moved to an SSIDwhose associated client
number is already reached its limit.
You can use the following commands to view the SSID details stored in client match:
The show ap client-match-ssid-table command displays the client match SSIDtable for the current W-IAP
and its neighboring W-IAPs.
The show ap client-match-ssid-table radio-mac <mac> command displays the client match SSIDtable for
a specific W-IAP denoted by its mac address.
Configuring Radio Settings
You can configure 2.4 GHz and 5 GHz radio settings for a W-IAP either using the Instant UI or the CLI.
In the Instant UI
To configure radio settings:
1. Click the RF link located directly above the Search bar of the Instant main window.