Concept Guide

Parameter Description Range Default
dot11h
Enable advertisement of
802.11d (Country Information)
and 802.11h (TPC or Transmit
Power Control) capabilities This
parameter is disabled by
default.
— disabled
high-throughput-enable
Enables high-throughput
(802.11n) features on a radio
using the 2.4 GHz frequency
band.
— enabled
ht-radio-profile
Name of high-throughput radio
profile to use for configuring
high-throughput support on the
5 GHz frequency band. See rf
ht-radio-profile on page 761.
— “default-a”
interference-immunity
Set a value for 802.11
Interference Immunity. The
default setting for this
parameter is level 2. When
performance drops due to
interference from non-802.11
interferers (such as DECT or
Bluetooth devices), the level
can be increased up to level 5
for improved performance.
However, increasing the level
makes the AP slightly “deaf” to
its surroundings, causing the
AP to lose a small amount of
range.
The levels for this parameter
are:
l Level-0: no ANI adaptation.
l Level-1: noise immunity
only.
l Level-2: noise and spur
immunity. This is the default
setting
l Level-3: level 2 and weak
OFDM immunity.
l Level-4: level 3 and FIR
immunity.
l Level-5: disable PHY
reporting.
NOTE: Do not raise the noise
immunity feature’s default
setting if the channel-reuse-
threshold on page 736 feature
is also enabled. A level-3 to
level-5 Noise Immunity setting
Level-0 -
Level-5
Level-2
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide rf dot11g-radio-profile | 750