Concept Guide

725| rf arm-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
load-aware-scan
-threshold
Load aware ARM preserves
network resources during
periods of high traffic by
temporarily halting ARM
scanning if the load for the
AP gets too high.
The Load Aware Scan
Threshold is the traffic
throughput level an AP must
reach before it stops
scanning. The supported
range for this setting is 0-
20000000 bytes/second.
(Specify 0 to disable this
feature.)
— 1250000
bytes/seconds
max-tx-power
Maximum effective isotropic
radiated power (EIRP) from 3
to 33 dBm in 3 dBm
increments. You may also
specify a special value of 127
dBm for regulatory
maximum to disable power
adjustments for
environments such as
outdoor mesh links. This
value takes into account both
radio transmit power and
antenna gain.
Higher power level settings
may be constrained by local
regulatory requirements and
AP capabilities.
3, 6, 9, 12, 15,
18, 21, 24,
27, 30, 33,
127
In 6.4.4.0 and
later releases:
l default-a:
18 dBm
l default-g: 9
dBm
In earlier 6.4.x
releases:
l default:
127dBm
min-scan-time
Minimum number of times a
channel must be scanned
before it is considered for
assignment. The supported
range for this setting is 0-
2,147,483,647 scans. Best
practices are to configure a
Minimum Scan Time
between 1-20 scans.
Default: 8 scans
1-
2,147,483,64
7
Recommend
ed Values: 1-
20
8 scans
min-tx-power
Minimum effective isotropic
radiated power (EIRP) from 3
to 33 dBm in 3 dBm
increments. You may also
specify a special value of 127
dBm for regulatory
minimum. This value takes
into account both radio
transmit power and antenna
gain.
3, 6, 9, 12, 15,
18, 21, 24,
27, 30, 33,
127
In 6.4.4.0 and
later releases:
l default-a:
12 dBm
l default-g: 6
dBm
In earlier 6.4.x
releases: