Concept Guide

ip radius
ip radius {nas-ip <ipaddr>|{nas-vlan <nas-vlan>}
rfc-3576-server udp-port <port>
source-interface {loopback|vlan <vlan>}
Description
This command configures global parameters for configured RADIUS servers.
Syntax
Parameter Description Range Default
nas-ip
A global NAS IP address to send in RADIUS packets
This can be specified by an IP address or a VLAN ID
— —
<ip-addr>
This IP address supersedes the server-specific NAS IP
configured with the aaa authentication-server
radius command.
— —
nas-vlan <nas-vlan>
Configure a RADIUS NAS IP for a branch controller
with a VLAN ID. If the NAS IP VLAN is not configured
for branch controllers, the controller IP defined in the
RADIUS server configuration address is used as the
NAS IP.
— —
rfc-3576-server
Configures the UDP port to receive requests from a
RADIUS server that can send user disconnect and
change-of-authorization messages, as described in
RFC 3576, “Dynamic Authorization Extensions to
Remote Dial In User Service (RADIUS)”. See the aaa
rfc-3576-server command to configure the server.
NOTE: This parameter can only be used on the
master controller.
— —
udp-port
UDP port to receive server requests. 0-
6553
5
3799
source-inter
face
Interface for all outgoing RADIUS packets. The IP
address of the specified interface is included in the IP
header of RADIUS packets. The interface can be one
of the following:
— —
loopback
The loopback interface. — —
vlan
The specified VLAN. — —
Usage Guidelines
This command configures global RADIUS server parameters. If the aaa authentication-server radius
command configures a server-specific NAS IP, the server-specific IP address is used instead.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ip radius | 533