Concept Guide

377| firewall Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
disable-stateful-sips-processing
Configure the controller to read
SIP signaling messages sent by
Skype4b clients on port 5061.
— enabled
disable-stateful-ua-processing
Disables stateful UA
processing.
— disable
d
disable-stateful-vocera-processing
Disables stateful VOCERA
processing.
— disable
d
dpi
Enables Deep-Packet
Inspection (DPI)
— disable
d
drop-ip-fragments
When enabled, all IP fragments
are dropped. You should not
enable this option unless
instructed to do so by a Dell
representative.
— disable
d
enable-bridging
Enables bridging when the
controller is in factory default.
— disable
d
enable-per-packet-logging
Enables logging of every packet
if logging is enabled for the
corresponding session rule.
Normally, one event is logged
per session. If you enable this
option, each packet in the
session is logged. You should
not enable this option unless
instructed to do so by a Dell
representative, as doing so
may create unnecessary
overhead on the controller.
— disable
d
enforce-tcp-handshake
Prevents data from passing
between two clients until the
three-way TCP handshake has
been performed. This option
should be disabled when you
have mobile clients on the
network as enabling this option
will cause mobility to fail. You
can enable this option if there
are no mobile clients on the
network.
— disable
d
enforce-tcp-sequence
Enforces the TCP sequence
numbers for all packets.
— disable
d