Concept Guide

2198| uplink Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Usage Guidelines
A controller that supports multiple 3G cellular uplinks in addition to its standard wired ports, provides
redundancy in the event of a connection failure. If a controller's wired link cannot access the internet, the
controller can fail over to a secondary cellular link and continue routing traffic.
The uplink manager is enabled by default on branch controller uplinks. Master or local (non-branch) controllers
using the PAN portal feature must issue the uplink enable command to enable the uplink manager.
To view the health status of an uplink on a master or local controller, issue the command show uplink in the
controller command-line interface. For a branch controller, the health status of its uplink connections are also
displayed in the Status section of the Dashboard > WAN page of the branch controller WebUI.
Related Commands
Command Description
pan-options
This command configures options to integrate a branch controller with a
Palo Alto Networks (PAN) firewall.
show uplink
Displays uplink configuration details.
Command History
Release Modification
ArubaOS 3.4 Command introduced
ArubaOS 6.0 The wired priority parameter is introduced.
ArubaOS 6.4.4.0 The health-check and cellular apn parameters were introduced.
Command Information
Platforms Licensing Command Mode
All platforms
Base operating system Config mode on master and local
controllers