Concept Guide

trusted
trusted all
Description
This command makes all physical interfaces on the controller trusted ports.
Syntax
Parameter Description
all
Makes all ports on the controller trusted.
Usage Guidelines
Trusted ports are typically connected to internal controlled networks. Untrusted ports connect to third-party
APs, public areas, or any other network to which the controller should provide access control. When APs are
attached directly to the controller, set the connecting port to be trusted.
By default, all ports on the controller are treated as trusted. You can use the interface fastethernet or
interface gigabitethernet commands to make individual ports trusted.
Example
The following command makes all ports trusted:
(host) (config) #trusted all
Command History
The command was introduced in ArubaOS 2.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide trusted | 2188