Concept Guide

213| ap system-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
Select dynamic or static to
enable this feature and select
the mode by which the
controller broadcasts the
backup ESSID. This feature is
disabled by default.
bkup-passwords <bkup-pass-
words>
Set a WPA passphrase to
generate PSK for backup
Virtual AP.
— —
ble-op-mode
Beaconing
Disabled
DynamicConsole
PersistentConsole
Determines how the built-in
Bluetooth Low Energy (BLE)
chip in the AP functions. BLE
chip can be in one of the
following four modes:
l Beaconing: The AP's built-
in BLE chip functions as an
iBeacon combined with
beacon management
functionality.
l Disabled: The AP's built-in
BLE chip is turned off. This
is the default setting.
l DynamicConsole: The
AP's built-in chip functions
as a regular iBeacon
combined with beacon
management functionality.
However, when the link to
the controller is lost, the
built-in chip temporarily
enables access to the AP
console over BLE. This
state of the BLE device
may be rolled back to any
of the other modes if the
AP receives a different
configuration setting for
the ble-op-mode
parameter from the new
LMS.
l PersistentConsole: The
AP's built-in chip provides
access to the AP console
over BLE using a mobile
application. This
functionality is the
superset of the Beaconing
mode.
NOTE: BLE is disabled on
ArubaOS FIPS build.
— disabled