Concept Guide

Parameter Description Range Default
ap-console-password <ap-con-
sole-protection>
Set the AP console password
on the controller. If the user
does not set any password,
the controller generates a
default random password
which can be viewed by
executing the encrypt
disable command followed by
the show ap system-profile
<profile-name> command.
6-32
characters
default
random
password
ap-console-protection
Enable the AP console
password.
— enabled
ap-usb-power-override
Enabling override enables the
USB port of the AP with POE
AT power.
— disabled
ip-or-dns
IP address or the DNS of the
AeroScout server to which
location reports are sent.
— —
port
Port number on the AeroScout
server to which location
reports are sent.
— —
bkup-band a|all|g
Band on which the controller
broadcasts the backup ESSID.
802.11a, all
bands, or
802.11g
all
bkup-lms-ip
In multi-controller networks,
specifies the IP address of a
backup to the IP address
specified with the lms-ip
parameter.
— —
bkup-lms-ipv6
In multi-controller ipv6
networks, specifies the IPv6
address of a backup to the
IPv6 address specified with
the lms-ipv6 parameter.
— —
bkup-mode
dynamic|off|static
This parameter allows AP
console access using a
backup ESSID, allowing users
to access an AP console after
the AP has disconnected from
the controller. When the AP
advertises a backup ESSID in
either static or dynamic mode,
a user is able to access and
debug the APremotely
through a virtual AP.
dynamic, off, or
static
off
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap system-profile | 212