Concept Guide

show wlan handover-trigger-profile
show wlan handover-trigger-profile [<profile-name>]
Description
Displays the current configuration settings for a handover trigger profile.
Usage Guidelines
Issue this command without the <profile> parameter to display a handover trigger profile profile list, including
profile status and the number of references to each profile. Include a profile name to display detailed
configuration information for that profile.
For this profile to take effect, the 802.11K feature needs to be enabled.
Example
(host) #show wlan handover-trigger-profile default
Handover Trigger Profile "default"
----------------------------------
Parameter Value
--------- -----
Enable Handover Trigger feature
Enabled
Threshold signal strength value at which Handover Trigger should be sent to the client 25 -
dBm
The output of this command includes the following information:
Parameter Description
Enable Handover Trig-
ger feature
Shows if the handoff trigger feature is enabled of disabled. If enabled, the
controller will initiate the handover of a voice client (for example: dual mode
handsets) roaming at the edge of Wi-Fi coverage to an alternate carrier or
connection. The handover trigger is initiated if the Wi-Fi signal strength
reported by the voice client (received from all APs) is equal to or less than the
threshold value.
Threshold signal
strength value at
which Handover Trig-
ger should be sent to
the client
Shows the threshold RSSI value below which a handover trigger message will
be sent to an associated client by the AP.
Command History
This command was introduced in ArubaOS 6.2.
Command Information
Platforms Licensing Command Mode
All platforms
Base operating system
Enable mode on master or local
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show wlan handover-trigger-profile | 2065