Concept Guide

203| ap regulatory-domain-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Default
52-56 Note: Changing
the country code
causes the valid
channel lists to be
reset to the
defaults for the
country.
valid-11a-80mhz-channel-group
This parameter defines which 80 MHz channels on
the “a” band are available for assignment by ARM
and for controller to randomly assign if the user
has not specified a channel. The channel numbers
below correspond to channel center frequency.
—
valid-11a-channel
Enter a single 802.11a channel number for 20
MHz operation within the specified regulatory
domain.
country code
determines
supported
channels
Note: Changing
the country code
causes the valid
channel lists to be
reset to the
defaults for the
country.
valid-11g-40mhz-channel-pair
Specify a channel pair valid for 40 MHz operation
in the 802.11g frequency band for the specified
regulatory domain. The two channels must be
separated by a dash.
Example:
1-5
2-6
7-11
country code
determines
supported
channel pairs
Note: Changing
the country code
causes the valid
channel lists to be
reset to the
defaults for the
country.
valid-11g-channel
Enter a single 802.11g channel number for 20
MHz operation within the specified regulatory
domain.
country code
determines
supported
channels
Note: Changing
the country code
causes the valid
channel lists to be
reset to the
defaults for the
country.
Usage Guidelines
This profile configures the country code and valid channels for operation of APs. The list of valid channels only
affects the channels that may be selected by ARM or by the controller when no channel is configured. Channels
that are specifically configured in the AP radio settings profile (see rf dot11a-radio-profile or rf dot11g-radio-
profile) must be valid for the country and the AP model.