Concept Guide

196| ap packet-capture Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
<target-ip>
IP address of the client running the packet analyzer.
<target-port>
UDP port number on the client station where the captured packets are sent.
radio <0-1>
ID of the radio sending the packets
channel <channel>
(Optional/Applicable only in Air Monitor mode) Number of a radio channel to
tune into to capture packets.
open-port <port>
(CPSECCAPs and RAPs only) Enable or allow access to this UDP port on the AP
for packet capture purposes.
pause
Pause a packet capture session.
ap-name <ap-name>
Name of the AP.
ip-addr <ip-addr>
IP address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
<pcap-id>
ID of the PCAP session.
radio <0-1>
ID of the radio sending the packets
raw-start
Stream packets from the driver to a client running the packet analyzer.
ap-name <ap-name>
Name of the AP.
ip-addr <ip-addr>
IP address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
<target-ip>
IP address of the client running the packet analyzer.
<target-port>
UDP port number on the client station where the captured packets are sent.
radio <0-1>
ID of the radio sending the packets
channel <channel>
(Optional/Applicable only in Air Monitor mode) Number of a radio channel to
tune into to capture packets.
maxlen <maxlen>
(Optional) Limit the length of 802.11 frames to include in the capture to a
specified maximum.
resume
Resume a packet capture session.