Concept Guide

show tunnel-group
show tunnel-group <tunnel-group-name>
Description
Displays the operational status of the tunnel-groups configured on the controller.
Syntax
Parameter Description
<tunnel-group-name>
Displays the operational status of the specified tunnel-group.
Example
The output of this command shows the status of the configured tunnel-groups:
(host) #show tunnel-group
Tunnel-Group Table Entries
--------------------------
Tunnel Group Type Tunnel Group Id Preemptive Failover Active Tunnel Id Tunnel Members
------------ ---- --------------- -------------------- ---------------- --------------
tgroup1 L3 16385 enabled 10 10 20
tgroup2 L2 16387 enabled 10 10 20 40
The output of the following command shows the status of the specified tunnel-group:
(host) #show tunnel-group tgroup1
Tunnel-Group Table Entries
--------------------------
Tunnel Group Type Tunnel Group Id Preemptive Failover Active Tunnel Id Tunnel Members
------------ ---- --------------- -------------------- ---------------- --------------
tgroup1 L3 16385 enabled 10 10 20
The output of the following command shows the datapath Tunnel-Group table entries:
(host) #show datapath tunnel-group
Datapath Tunnel-Group Table Entries
-----------------------------------
Tunnel-Group Active Tunnel Members
------------ ------------- ---------
16385 10 10 20
Command History
Release Modification
ArubaOS 6.3 Command introduced.
ArubaOS 6.4.2.3 The Type parameter was introduced as part of this command output.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show tunnel-group | 1926