Concept Guide

1860| show rf event-thresholds-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Frame Retry Rate High Watermark 16 %
Frame Retry Rate Low Watermark 8 %
The output of this command includes the following parameters:
Parameter Description
Detect Frame Rate
Anomalies
Shows of the profile enables or disables detection of frame rate anomalies.
Bandwidth Rate High
Watermark
If bandwidth in an AP exceeds this value, it triggers a bandwidth
exceeded condition. The value represents the percentage of maximum
for a given radio. (For 802.11b, the maximum bandwidth is 7 Mbps. For
802.11 a and g, the maximum is 30 Mbps.) The recommended value is
85%.
Bandwidth Rate Low
Watermark
If an AP triggers a bandwidth exceeded condition, the condition persists
until bandwidth drops below this value.
Frame Error Rate High
Watermark
If the frame error rate (as a percentage of total frames in an AP) exceeds
this value, it triggers a frame error rate exceeded condition.
Frame Error Rate Low
Watermark
If an AP triggers a frame error rate exceeded condition, the condition
persists until the frame error rate drops below this value.
Frame Fragmentation Rate
High Watermark
If the frame fragmentation rate (as a percentage of total frames in an AP)
exceeds this value, it triggers a frame fragmentation rate exceeded
condition.
Frame Fragmentation Rate
Low Watermark
If an AP triggers a frame fragmentation rate exceeded condition, the
condition persists until the frame fragmentation rate drops below this
value.
Frame Low Speed Rate
High Watermark
If the rate of low-speed frames (as a percentage of total frames in an AP)
exceeds this value, it triggers a low-speed rate exceeded condition.
Frame Low Speed Rate Low
Watermark
After a low-speed rate exceeded condition exists, the condition persists
until the percentage of low-speed frames drops below this value.
Frame Non Unicast Rate
High Watermark
If the non-unicast rate (as a percentage of total frames in an AP) exceeds
this value, it triggers a non-unicast rate exceeded condition. This value
depends upon the applications used on the network.
Frame Non Unicast Rate
Low Watermark
If an AP triggers a non-unicast rate exceeded condition, the condition
persists until the non-unicast rate drops below this value.
Frame Receive Error Rate
High Watermark
If the frame receive error rate (as a percentage of total frames in an AP)
exceeds this value, it triggers a frame receive error rate exceeded
condition.
Frame Receive Error Rate
Low Watermark
If an AP triggers a frame receive error rate exceeded condition, the
condition persists until the frame receive error rate drops below this value.